If you double click on the upper half of the Server card, you will get to the server configuration view:

At the bottom you find a tab bar, containing 6 tabs:

  1. Devices — where you set up your sensors and place them on areas and layers.
  2. Triggers — where you set triggers to execute Actions (see Actions).
  3. Timer — where you set up timers for scheduled executions of Actions.
  4. Data Viewer — where you can find current sensor data. The sensor values are visible in this tab.
  5. Log Viewer — where you can find the Gravio Server logs for debugging and optimisations.
  6. Settings — where you can find server related settings and perform backups.

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment