Note: This documentation refers to Gravio 3.8 or older. For Gravio 4 or newer, please refer to the respective documentation on doc.gravio.com . |
The PATLITE action component can control lights and play audio on Patlite network-enabled watch towers. The watch tower must support HTTP commands. For more information, please check the Patlite website. https://www.patlite.co.jp/
This component is convenient to control the lights and signals according to the information from the sensors.
Component Properties
IP Address | Watch Tower IP Address | |
---|---|---|
Red | Controls the red lamp | On / Off / Blink1 / Blink2 / No Change |
Yellow | Controls the yellow lamp | On / Off / Blink1 / Blink2 / No Change |
Green | Control green lamp | On / Off / Blink1 / Blink2 / No Change |
Blue | Control blue lamp | On / Off / Blink1 / Blink2 / No Change |
White | Control white lamp | On / Off / Blink1 / Blink2 / No Change |
Play Sound | Check to play audio | |
Sound Channel | Specify the number of the channel to be played. For details, refer to the device manual. | Example: 65 |
Repeat | Specify an additional number of repeated playbacks. Leave blank if not repeated. | Example: 1 will be played twice |
Timeout | API timeout |