The Patlite Action Component is to control a PATLITE network device including audio. The watchtower must support HTTP commands. For more information, please visit the Patlite website. https://www.patlite.co.jp/

PATLITEs are useful to control the display according to the information from the sensors.

Output Payload Description
cv.Payload Outputs the output payload of the previous component as is. (Pass-through)

Component Properties

Name Required Description
IP address True The IP address of the watchtower
Red True Set to either On/Off/Blink1/Blink2/No Change. [The values to set for cp.Red are “off”, “on”, “blink-1”, “blink-2”, “no-change”].
Amber True Set to either On/Off/Blink1/Blink2/No Change [The values to set for cp. Amber are “off”, “on”, “blink-1”, “blink-2”, “no-change”].
Green True Set to either On/Off/Blink1/Blink2/No Change [The values to set for cp. Green are “off”, “on”, “blink-1”, “blink-2”, “no-change”].
Blue True Set to either On/Off/Blink1/Blink2/No Change [The values to set for cp.Blue are “off”, “on”, “blink-1”, “blink-2”, “no-change”].
White True Set to either On/Off/Blink1/Blink2/No Change [The values to set for cp.White are “off”, “on”, “blink-1”, “blink-2”, “no-change”].
Play Sound True Play Sound
Sound Channel True Specify the channel to be played back using numbers. For details, see the manual for the device.
Repeat True Specifies the number of additional repetitions. If you don’t want to repeat it, leave it blank.
Timeout False Timeout (ms)

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.