This section will explain the initial setup of Gravio Hub 2.
In order to use the Gravio Hub 2, you will need to do the following two things
- Configure WiFi network settings to connect Gravio Hub 2 to your network.
- Gravio Hub 2 is running on a Ubuntu2004-based LinuxOS. It is designed to be able to login to LinuxOS if necessary. For this reason, change the password in the UpdateManager default settings to increase the security of the login account password for logging into Linux.
Please prepare your WiFi network settings (name and password of the network to connect to) and the new password to be set for the login account in advance.
Note: Please save the password for the new login account in a safe place. If you lose the password, you will not be able to log in to Linux.
The following accessories are rented with the Gravio Hub 2, including the following Gravio Hubs
- Gravio Hub2 main unit
- Gravio USB-C cable
- Power supply box
Gravio Hub2 has one USB-A connector, one USB-C connector, one wired LAN connector and one HDMI connector.
install Gravio Hub2 in your LAN
Configure the Wifi settings for the Gravio Hub2. See here.
If you wish to use the Gravio Hub2 over a wired LAN, you must also configure the Wifi settings, change the settings to wired LAN using UpdateManager, and then connect the LAN cable to the wired LAN connector.
boot up the Gravio Hub2
Connect the USB-C cable to the USB-C connector on the Gravio Hub2 to start up.
Need more help with this?
Join our slack community for help