For wired LAN connection
Connect the wired LAN cable to the LAN connector on the Gravio Hub2.
Note: Please use a wired LAN that can provide an IP address via DHCP.
Boot up the Gravio Hub2
Connect the USB-C cable to the USB-C connector on the Gravio Hub2 and start it up.
For wireless LAN connection
Boot up the Gravio Hub2
Connect the USB-C cable to the USB-C connector on the Gravio Hub2 to boot up.
Configure Wifi settings on Gravio Hub2
Connect the Gravio Hub to a power source and start it up.
When the light at the front of the Gravio Hub appears blue, connect to the SSID named GravioHubXXXXXXXXXXXXX from your PC’s Wifi.
The WiFi password is “graviohub”.
After connecting, open the Gravio Configuration Manager by typing “http://192.168.100.1:8080” in your browser.
Then go to the “Gravio Hub configuration” and proceed to configure the time and date settings, the regional settings, and Gravio Hub Internet settings.
Need more help with this?
Join our slack community for help