In For wired LAN connection
Connect a wired LAN cable to the LAN connector on the Gravio Hub X64.
Please use a wired LAN that supports DHCP at this time.
Start up the Gravio Hub X64
Connect a USB-C cable to the USB-C connector on the Gravio Hub X64, then connect it to a power source and press the start button to start up.
If you are connected via a wired LAN and an IP address has been allocated via DHCP, connect a display and keyboard to the Gravio Hub X64 and
login to the console with the following username and password
Username : gravio
Password : gravio
After that, check the allocated IP address using “ip addr” from the console, and open the Gravio Configuration Manager by entering “http://ip address:8080” from your browser.
Next, go to “Gravio Hub Settings” and set the time and the internet settings for the Gravio Hub.
For wireless LAN connections
Starting up the Gravio Hub X64
Connect the USB-C cable to the USB-C connector on the Gravio Hub X64, then connect it to the power supply and press the start button to start it up.
Configure the Gravio Hub X64 to connect to your own WiFi access point.
In this case, unplug the wired LAN cable.
After starting up Gravio Hub X64, connect to the SSID named GravioHubXXXXXXXXXXX on your PC.
The WiFi password is “graviohub”.
After connecting, open the Gravio Configuration Manager by entering “http://192.168.100.1:8080” in your browser.
Next, go to “Gravio Hub Settings” and set the time, region and internet settings for Gravio Hub.
Need more help with this?
Join our slack community for help