Gravio Studio cannot find or connect to HubKit

if you cannot find HubKit from Gravio Studio

Gravio Hub.

1. Log in the HubKit’s IP address on the HubKit console and check the wlan0 IP address for wireless using ifconfig.
2. Run ping from the PC in Gravio Studio to see if it connects to the relevant Gravio Hub.
3. If it is connected, press the “+” icon on the Gravio Studio Hub list screen and try to add the Hub with that IP address.
   

Windows

1. If you installed HubKit before installing Gravio Studio, you will not be able to see HubKit from Gravio Studio on the same machine. (Due to Windows OS Sandbox limitation.)
   In this case, uninstall HubKit, install Gravio Studio, and then install HubKit.
2. If not above, check the IP address of the PC concerned, and try to add a Hub with that IP address by pressing the “+” icon on the screen of the list of Hubs in Gravio Studio.
   

I get a connection error when I click on a Hub that appears in the list of Hubs in Gravio Studio.

Gravio Hub.

1. Log in the HubKit’s IP address in the HubKit’s console and use ifconfig to check the wlan0 IP address for wireless
2. Run ping from the PC of Gravio Studio to see if it connects to the relevant Gravio Hub.
3. Click the edit button on the HubKit card in Gravio Studio, enter the IP address in the “Hub IP” field, save it, and click the card again. h3.
   

Windows

1. Confirm the IP address of the PC in question, press the Edit button in the HubKit card of Gravio Studio with that IP address, enter the direct value of the IP address in the “Hub IP” field, save it, and click on the card again.

Translated with www.DeepL.com/Translator (free version)