This document explains the steps to restore the Gravio Hub X64 to its factory settings using an SDCard.

  1. Connect a display and keyboard to the Gravio Hub X64.
  2. Insert the SDCard included in the Gravio Hub X64 package into the SDCard slot of the Gravio Hub X64.
  3. Press the power button on the Gravio Hub X64 to turn it on.
  4. Upon startup, a single line of text will appear on the display. Press the Enter key on the keyboard at this point. The OS image will be transferred from the SDCard to the internal disk of the Gravio Hub X64.
  5. Once all transfers are complete, the device will automatically shut down.
  6. Remove the SDCard.
  7. Press the power button again to start the Gravio Hub X64.
  8. After the boot process is complete, the Login screen will appear. (The internal initialization process will take about 3 minutes at this point. Please do not turn off the power and leave it as is.)
  9. At the login prompt log in with username gravio and password gravio After logging in, enter the command sudo docker ps and confirm the display appears as shown below. If the display matches the example, proceed to the next step.
  10. Shut down the device and restart it.

The process to restore the Gravio Hub X64 to its factory settings is now complete.

The Initialize Disk included in the package looks like this:

Need more help with this?
Join our slack community for help

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.